SoFunction
Updated on 2025-04-13

Resolution of restart failure caused by memory incompatibility

Resolution of restart failure caused by memory incompatibility

Updated: March 13, 2008 22:09:20 Author:
Q: A computer has always used Samsung DDR333 512MB memory. Recently, after adding a Kingston DDR333 512MB memory, the computer often has automatic restart problems. What is the problem caused by this?
Answer: This problem is generally caused by memory incompatibility. It is recommended that you try the following methods to solve the problem: First, start the computer, enter the motherboard BIOS settings, adjust the motherboard BIOS memory parameters, set it to "AUTO" or lower the relevant parameter values, and see if the fault can be resolved. Secondly, insert new memory separately to see if the problem can be solved. If the fault is eliminated, it will be proved to be caused by the incompatibility of the two memory lines. If the fault still exists, it means that the new memory itself has quality problems. The above two situations can be solved by replacing a memory without quality problems.
  • Memory incompatible
  • Restart

Related Articles

  • Computer speed up memory

    The larger the memory, the faster the machine? I think most people's answers are yes. The prompt from 256M to 512M is obvious, so for granted, the improvement from 512M to 1G will be very obvious. But I use my personal experience to tell you that 1G memory is slower than 512M, of course, the premise is that you don’t set anything.
    2008-03-03
  • The reasons and treatment methods for "blue screen"

    The reasons and treatment methods for "blue screen"...
    2006-12-12
  • Reprinting to understand one of the terms for hard disk

    Reprinting to understand one of the hard disk terms...
    2006-12-12
  • What is the focus performance of CRT tubes

    What is the focus performance of CRT tube...
    2007-12-12
  • The solution to the system cannot find the optical drive. The computer cannot find the optical drive.

    Two days ago, when I turned on the computer, I suddenly found that the optical drive of the system could not be found. Depressed, I didn't do anything, thinking it was a problem with the data cable, but after all, I still looked the same
    2008-08-08
  • Two cases of repairs without word marks in laser printer

    Two cases of repairs without word marks in laser printers...
    2007-12-12
  • Maintenance and optimization of laptop batteries

    Maintenance and optimization of laptop batteries...
    2007-04-04
  • Conflict and solution of computer hardware resources

    Conflicts and solutions to computer hardware resources...
    2006-12-12
  • Analysis of the fault of the pin printer font car

    Analysis of the fault of the pin printer car...
    2007-12-12
  • How to identify second-hand repaired boards

    How to identify second-hand repaired board cards...
    2006-12-12

Latest Comments